Key Features of 1GE mini ONT fiber modem
- Automatic EPON/GPON mode switching
- Supports HGU (Home Gateway) and SFU (Single Family Unit) modes
- Dual IPv4/IPv6 routing and bridging
- Advanced firewall and ACL security features
- IGMP Snooping/Proxy for multicast optimization
- Low power consumption (≤3W) and compact design (21.5mm × 92mm)
Technical Specifications of 1GE mini ONT fiber modem
| Interface | Details |
|---|---|
| PON Port | 1x G/EPON (SC/UPC), 20km range, 1310nm TX / 1490nm RX |
| LAN Port | 1x 10/100/1000Mbps auto-adaptive Ethernet (RJ45) |
| Power Supply | 5-12V USB Type-C |
| Dimensions | 21.5mm × 17mm × 92mm |
| Operating Temp | 0°C to +50°C |
| Compliance | ITU-T G.984.x (GPON), CTC3.0 (EPON) |
Application Scenarios
1GE Internet Service with VLAN-100
- SFU Mode: Direct VLAN configuration via OLT. Clients obtain IP via ISP DHCP/PPPoE.
- HGU Mode: Route WAN connection with ONU-managed VLAN and DHCP services.
Configuration Highlights
- Web-based management (default IP: 192.168.1.1)
- WAN setup: PPPoE, DHCP, or static IP
- LAN DHCP server, IPv6 RA, and prefix management
- Port forwarding, MAC filtering, and loopback detection
- Firmware upgrade and configuration backup
Frequently Asked Questions
Why is the LAN LED off?
Causes: Loose cable, incorrect cable type, or excessive length.
Fix: Reconnect or replace with CAT5e/CAT6 cable.
Why does the PON/LOS LED blink red?
Causes: Dirty fiber connector or faulty PON module.
Fix: Clean the connector or contact your ISP.
How to reset to factory settings?
Navigate to Administration > Device Management > Restore Default.
